![]() ![]() LiteSpeed Enterprise – suitable for hosting multiple websites or a shared hosting environment.There are two editions of the LiteSpeed web server available: Additionally, it works with several popular hosting control panels, such as WHM, DirectAdmin, and Plesk. htaccess support, letting users switch from Apache and use existing configurations. The LiteSpeed server also has a built-in Apache replacement with. Built with event-driven architecture, the LiteSpeed server can handle higher traffic with fewer processes, reducing resource usage and improving page speed. Notice how *:80 (http) enacts a rewrite to *:443 (https), which then enforces SSL with the SSLEngine on directive.LiteSpeed is web server software designed to accelerate a website’s performance. SSLCertificateChainFile /var/www/ssl/STAR_iconcierge_net_au.crt SSLCertificateKeyFile /var/www/ssl/STAR_iconcierge_net_au.key SSLCertificateFile /var/www/ssl/STAR_iconcierge_net_au.crt So, here are my s (all in /etc/apache2/sites-available/nf but might be different depending on your setup): SSLEngine onĪfter removing those lines from *:80 (and making sure they were present under ) My server popped back up again. The more direct issue was that I had the following SSL details under my *:80 host, which was making Apache try to enable SSL for a non-SSL connection. Any sites that start with will be funneled through port 443 ( ) Any website address that starts with will be funneled through port 80 ( ) and that host doesn't want to know anything about SSL. I had this same error and the culprit was that my config was trying to enable SSL on my non-ssl port. If you try such requests with other servers then they would either close the connection without any error at all or just hang because they are still hoping to get a TLS handshake from the client. Instead use the HTTPS scheme to access this URL, please. Reason: You're speaking plain HTTP to an SSL-enabled server port. Apache is at least nice enough to check if the incoming data for a plain HTTP request in this case so that it can offer you a more useful description: But the server is expecting TLS there which means that your plain HTTP request is unexpected. ![]() Your URL of is causing the browser to make a plain HTTP request to port 443. Instead they expect the client to behave properly, that is use plain HTTP on one port (usually 80) and HTTPS on another port (usually 443). or similar) or is starting a TLS handshake ( \x16\x03.) most web servers don't do this. While it would be in theory possible to figure out based on the first data from the client if the client is sending a HTTP request (i.e. TL TR: you cannot serve both HTTP and HTTPS on the same port (443). Possibly related, trying to do a dry run of letsencrypt returns the following: Domain: ĭetail: Failed to connect to 123.123.123.123:443 for TLS-SNI-01įor each and every domain listed in the sites-enabled folder. This issue occurs on all domains, subdomains and the server IP itself. I tried including the following lines in my nf in the : RewriteEngine On ![]() Instead use the HTTPS scheme to access this URL, please.Īpache/2.4.18 (Ubuntu) Server at Port 443 Your browser sent a request that this server could not understand. When testing something like :443, it does not redirect correctly to, I instead get hit with a 400 Bad Request page with the following content: So for posterity sake, I am trying to configure my server so that even when someone tries to go to go to :443, they would be correctly redirected to the https version of the site ( ). ![]()
0 Comments
Leave a Reply. |